Avid Technology AS3000 Guide d'installation télécharger pdf (Page 46)

Installing and Removing a PCIe Add-in Card

3. Disconnect the AC power cords.

4. Unscrew the thumbscrews at the back of the unit until they are loose.

5. Pull the thumbscrews backwards and slide the cover until the tabs disengage from the front

of the unit.

Removing the Server System Cover

A. Thumbscrews

6. Remove the cover and set in a safe place.

To install the server system cover:

1. Place the cover over the server system so that the side edges of the cover sit just outside the

server system sidewalls.

2. Slide the cover forward until it clicks into place. As necessary, press down on the tabs near

the front of the cover so that they slide under the top front of the server.

3. Tighten the rear thumbscrews.

4. Reconnect all peripheral devices and the AC power cords.

Installing and Removing a PCIe Add-in Card

This section describes how to install and remove a PCIe add-in card.

To install a PCIe add-in card:

1. Observe the safety precautions described in “Electrostatic Discharge Precautions” on

page 37 and “Safety and Regulatory Information” on page 70.

2. Power down the server and unplug all peripheral devices and the AC power cables.

wwww

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 82 83

Pas de commentaire

Avid Technology AS3000 Guide d'installation Page 46