Avid Technology Rack-Mount Kit Guide de l'utilisateur télécharger pdf (Page 17)

Chapter 3: Installation 13

Connecting Only DigiDrive

Enclosures

The following procedure explains how to con-

nect a DigiDrive. Stack the drives before connect-

ing any cables and turning the drives on.

To connect DigiDrive enclosures:

1 Attach the 68-pin SCSI connector from the

computer's SCSI host bus adapter to either SCSI

connector on the DigiDrive

2 If you have more than one DigiDrive, locate

the SCSI cable with 68-pin connectors on both

ends in the next drive kit.

3 Attach one end of the cable to the remaining

SCSI connector on the ﬁrst DigiDrive in the

drive stack (see Figure 9). Secure the cable by us-

ing the thumbscrews that are part of the cable

connector.

4 Repeat steps 2 through 5 until you have all the

drives connected.

5 Attach the other end to either SCSI connector

on the next DigiDrive in the drive stack. Secure

the cable by using the thumbscrews that are part

of the cable connector.

To avoid bending pins, make sure the 68-

pin cable is perpendicular to the back panel

and properly aligned before inserting.

Figure 8. SCSI Cable to First DigiDrive Connection

DigiDrive

68-pin SCSI cable from computer's SCSI

host bus adapter or other drives

Figure 9. Additional DigiDrive Connection

DigiDrive

pin to 68-pin

15-inch SCSI cable

68-pin SCSI cable from computer's SCSI

host bus adapter or other drives

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 49 50

Pas de commentaire

Avid Technology Rack-Mount Kit Guide de l'utilisateur Page 17