Avid Technology System 5 Spécifications télécharger pdf (Page 16)

Chapter 1: Introduction to the S3L System 5

Operational Requirements

Temperature and Ventilation

S3L system devices should be operated away from heat sources

and with adequate ventilation.

Storage

S3L system devices should be stored and transported at tempera-

tures not lower than 0 degrees F (–18 degrees C) and not exceed-

ing 140 degrees F (60 degrees C).

Operation

S3L system devices should be operated at temperatures not lower

than 40 degrees F (4 degrees C) and not exceeding 104 degrees F

(40 degrees C).

During operation, the bottom panels of the S3 control surface, the

front and back panels of E3 engine, and the side panels of the

Stage 16 should be exposed to ambient air. Do not block the ven-

tilation holes on any S3L system component.

Do not operate in direct sunlight or at extreme ambient tempera-

tures.

Water and Moisture

S3L system devices should be operated away from sources of di-

rect moisture and should be kept clear of liquids that might spill

into the units. If condensation is present on the unit, leave the unit

to dry in ambient air for at least one hour before powering the unit

on.

Cleaning and Maintenance

Use a dry cloth to clean the surfaces of the S3L components. Do

not apply any cleaning solutions, spray cleaners, or abrasives to

the surface.

Connection Requirements

Power Connections

Power connections on all S3L system devices are auto voltage-se-

lecting (100 to 240V nominal, 90-260V maximal, 50–60 Hz).

Make sure your power source is correctly rated for the number of

units you are connecting. A surge-protected power source (not in-

cluded) is highly recommended.

Audio Connections

• All audio inputs and outputs (except Headphones) are bal-

anced XLR and/or balanced 1/4-inch connections.

• All 1/4-inch connections support balanced (TRS) and un-

balanced (TS) connections.

• All external digital audio inputs and outputs are AES/EBU

(XLR) connections.

Audio Network Connections

Shielded Cat 5e (350 MHz) or better Ethernet cable with Neutrik

etherCON

connectors are required for primary and redundant au-

dio network connections between the console, the E3 engine, and

any Stage 16 boxes. Maximum distances of 100m are supported

for all audio network connections.

Pro Tools Connections

Shielded Cat 5e (350 MHz) or better Ethernet cable with RJ-45

connectors is required for the Ethernet AVB connection to

Pro Tools.

ECx Ethernet Control Connections

Standard Cat 5e Ethernet cable with RJ-45 connectors are sup-

ported for ECx remote control connections to a client computer or

wireless/wired router.

System Requirements and

Compatibility

Avid can only assure compatibility and provide support for hard-

ware and software it has tested and approved. For complete sys-

tem requirements and a list of qualified computers, operating sys-

tems, hard drives, and third-party devices, visit:

www.avid.com/compatibility

Hardware monitoring and automatic warnings are provided

for temperature, power and other factors. For more informa-

tion, see “Hardware Monitoring Window” on page 294.

Storage humidity range 5% to 95%, non-condensing

Operating humidity range 20% to 80%, non-condensing

For more information on audio connectors and specifica-

tions, see Chapter 27, “Audio Specifications.”

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 312 313

Commentaires sur ces manuels

Pas de commentaire

Modelos	Tipo de documento
Fashion Mate 7256	Manual de usuario Инструкция по эксплуатации SINGER Fashion Mate 7256, 40 paginas
FEATHERWEIGHT FW-75	Manual de usuario Singer FEATHERWEIGHT FW-75 User's Manual, 4 paginas
FUTURA CE-150	Manual de usuario Singer FUTURA CE-150 User's Manual, 127 paginas
FUTURA CE-250	Manual de usuario Singer FUTURA CE-250 User's Manual, 4 paginas
Futura SES2000	Manual de usuario Singer Futura SES2000 User's Manual, 4 paginas
FUTURA XL-400	Manual de usuario Singer FUTURA XL-400 User's Manual, 112 paginas
FW75	Manual de usuario Singer FW75 User's Manual, 36 paginas

Avid Technology System 5 Spécifications Page 16

Commentaires sur ces manuels

SINGER Máquinas De Coser manuales de usuario