Avid Technology System 5 Guide de l'utilisateur télécharger pdf (Page 67)

Chapter 6: Channels and Strips 61

Chapter 6: Channels and Strips

Strips

A CM408T module contains eight identical Strips, each with independent Main and Swap channels. The Strip is the console’s

physical control area that contains switches, knobs, displays, and a fader. The figure below shows a Strip, its displays that appear

on the meter bridge above the channel, and block diagrams for the Swap and Main channels.

System 5 has several innovative, efficient methods that manage channel-to-Strip mapping and channel settings:

• Any channel can be assigned to any Strip, and assignments need not be consecutive.

• Two Strips can control one channel, so two users can simultaneously operate that channel.

• Channels with related functions (i.e., individual drums, drum submixes) can be assigned to neighboring Strips.

• Channel-to-Strip mappings can be named, stored, and recalled as Layouts (see “Layouts” on page 113).

• Channel settings can be named, stored, and recalled as Snapshots (see “Snapshots” on page 116).

A 48-Strip/96-channel configuration could map all channels to the control surface:

• Main (channels 1–48 to Strips 1–48)

• Swap (channels 49–96 to Strips 1–48)

A 24-Strip/96-channel configuration cannot map all channels to the console at once but could use two Layouts to easily inter-

change all channels.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 189 190

Pas de commentaire

Avid Technology System 5 Guide de l'utilisateur Page 67